Terex Fuchs MHL380 D User Manual

SAFETY AND ACCIDENT PREVENTION 2
MHL380 D 2.3
2.2.1 Avoiding crushing and burns
 Do not work under the loading equipment
unless it is resting safely on the ground or is
fully supported.
 Do not work underneath the cab or
underneath the lift frame when the cab is
raised and not secured by a support sleeve.
 Do not use any restraining devices such as
cables or chains that are damaged or do not
have sufficient carrying capacity. Wear
safety gloves when working with wire cables.
 Never use your fingers to align the holes
when working on the equipment. Use a
suitable mandrel instead.
 Check that there are no hands or objects
that could be pulled into the fan when the
diesel engine is running. The fan can cause
severe injuries, eject or destroy objects, or
be damaged itself by these objects.
 Close to the operating temperature, the
entire engine cooling system is hot and
pressurized. Avoid touching parts that carry
coolant. There is a risk of burns.
 Only check the coolant level if the cap of the
expansion container has cooled off enough
for you to hold it. Then turn the cover
carefully to first release the excess pressure.
 Close to the operating temperature, the
engine oil and hydraulic fluid are hot. Avoid
touching hot oil or parts carrying oil.
 Wear protective goggles and protective
gloves when you are working on the battery.
Avoid sparks and naked flames.
 Never allow a helper to guide the grab
manually.
 Before performing any work in the engine
compartment, always use the supports
provided to prevent the engine cover closing
unintentionally.
 There is a risk of being crushed by the lift
frame due to the movement of the cab, since
the operator in the cab cannot see all areas
fully. The same kind of risk applies when
lowering the elevating cab in an emergency
using the ball valves provided.
h Chapter 4.11.6 Emergency lowering of
cab

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English