Terex Fuchs MHL380 D User Manual

SAFETY AND ACCIDENT PREVENTION 2
MHL380 D 2.13
2.3.2 Safety instructions for replacing
the (optional) XENON lamp
 Always switch the headlamp off and isolate it
from the supply voltage before changing the
lamp.
 Never touch the inside of the lamp fitting.
 The electrical connection between headlamp
and ballast conducts high voltage and must
not be disconnected.
 The ballast (electronic component in the
headlamp housing) must never be operated
without a lamp, as dangerous voltage
flashovers can occur which may cause
damage.
 Let the lamp cool down first.
 Wear safety goggles and safety gloves when
changing the lamp.
 The glass body of the XENON lamp is filled
with various gases and metal gases and is
pressurized. (Risk of splintering!).
 Never touch the glass lamp of the XENON
lamp, hold it only at the base.
 Carefully remove fingerprints with a clean
cloth and spirit.
 The XENON lamp should only be operated
in a sealed headlamp.
 Should the XENON lamp burst in an
enclosed space, the room must be aired for
at least 20 minutes to eliminate health risks
due to gases.
 Dispose of the old XENON lamp as
hazardous waste.
 To ensure that the permissible current
intensity for the cable and plug connections
is not exceeded, do not connect any further
working headlamps in parallel with the
existing ones; this will stop fuses blowing.
 Do not replace fuses for electric circuits with
fuses that have a higher current rating –
otherwise, there is a risk of fire!
ATTENTION
In the event of continuing starting
difficulties when switching on
(flickering light), switch the XENON
headlamp off immediately.
Otherwise the electronics in the
ballast might be damaged beyond
repair.

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English