RECOVERY, LOADING, AND TRANSPORT 6
MHL380 D 6.7
â–º
Once the machine has been loaded onto
the flat bed trailer, the uppercarriage must
be secured against the undercarriage to
prevent the uppercarriage from turning
(swing brake engaged).
â–º
Secure the machine and other piece parts
against slipping with chains and chocks, in
compliance with national requirements for
loading and transport.
â–º
Before leaving the machine, relieve all
pressure lines of pressure (as described in
the operating instructions), remove the ig-
nition key and fold up the left armrest.
â–º
Close all cab and paneling doors.
â–º
Ensure no one is on the machine during
transport.
â–º
Before setting off, find out about the route
to be taken, especially with regard to limits
for width, height and weight.
â–º
Pay close attention when driving under
electrical lines and bridges or driving
through tunnels.
â–º
When unloading, proceed as cautiously as
when loading.
Fig. 154 Flat-bed trailer loading
To Next Page
Loading...
Need help?
General
