Terex Fuchs MHL380 D User Manual

7 CARE AND MAINTENANCE
7.40 MHL380 D
►
Switch off the diesel engine.
►
Unscrew the protective cap from the drain
valve (185/1).
►
Screw the oil drain hose included in the
scope of supply (185/2) onto the drain
valve (185/1) on the oil pan and collect the
oil in a suitable container.
ATTENTION
Collect old oil with a suitable reser-
voir. Do not allow it to seep into the
ground or water! Give to an author-
ized waste disposal company to
dispose of in an environmentally-
friendly manner.
►
Remove the oil drain hose (185/2) and
screw the protective cap onto the drain
valve (185/1).
►
Change the engine oil filter.
h Chapter 7.9.1.3 Changing the engine oil
filter
►
Remove the cap (186/1).
►
Add oil until the level reaches the top mark
on the oil-level dip-stick (186/2).
►
Close the cap (186/1).
►
Start the diesel engine and run at a low idle
for approx. 2 minutes.
►
Switch off the diesel engine.
►
Check the oil level after approx. 15 minutes
and top up if necessary.

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English