TomTec QUADRA 4 - Move Arm

Quadra 4 Operator Manual
Tomtec
66
Aspirate Speed
See Aspirate Function.
Aspirate Height
See Aspirate Function.
Dispense Speed
See Dispense Function.
Dispense Height
See Dispense Function.
Additionally, refer to Section “3.37” Program Operations Common Options on page 89 for
information on other parameters used by this function.
3.16 Move Arm
The move arm operation is used to change the position of the device as well as open /
close the hand.
Conditions
None
Remarks
Set Hand (before move)
Indicates the state of the hand before and during the move.