Quadra 4 Operator Manual
Tomtec
48
3.0 Program Operations
This section contains detailed information on all of the various program operations in
alphabetical order. Note: Based on the configuration of your Quadra, some of these
functions may not be available.
3.1 Alert Timer
The "Alert Timer" can be used to remind the operator of a task to be done.
Conditions
None
Remarks
Total Time
A minimum of one(1) minute to 1440 minutes(24 hours) can be programmed. If zero
time is issued, the current alert timer will be canceled.
Warn Time
Time remaining from the total time to issue a warning to the operator(0 to 10 minutes). If
zero(0) time is used, no warning will be issued.
The example above will alert the operator in 10 minutes, with warning issued with 2
minutes remaining.
When an alert is issued, the time will be posted on the shuttle image on the Main
Screen. This timer will count down, to show how much time is left before the Alert.
When the warning time is reached, the shuttle will turn RED, and the cancel alert button
will be displayed.
To Next Page
Loading...