Quadra 4 Operator Manual
Tomtec
56
The ‘Dispense Tip Dip’ Value, by default, cannot exceed (be less than)
the Dispense Height. This is to prevent the Dip Tip function from never
reaching the liquid.
If Liquid Following is enabled, however, the restraint on the Dispense Tip Dip
value is lifted, due to the fact that the ending height after the Dispense Function
has been completed may be higher than the Dispense Height Value, or
the height at which the Dispense Function actually began. It is up to the user
from this point to estimate approximately how far within the well the liquid will
begin after the Dispense function has completed.
Additionally, refer to Section “3.37 Program Operations Common Options” on page 89
for information on other parameters used by this function.
3.7 Empty Sample
To dispense all liquid from tips completely.
Conditions
To Empty Sample, you will need to select a shuttle position that contains a plate or
reservoir capable fixture.
Remarks
To Next Page
Loading...