Quadra 4 Operator Manual
Tomtec
132
9.0 System Parameters
The Quadra 4 firmware parameters are set by qualified Tomtec personnel during assembly.
Conditions
A password is required to change all but a few non-critical system parameters.
If a critical parameter has to be changed, you should contact Tomtec's Technical Support
department at 203.281.6790.
The pictures shown do not represent actual instrument settings.
The Quadra 4 system parameters are password protected, but you can view them
by clicking the "Cancel" button on the password prompt without a password entry.
To Next Page
Loading...