173
8. SETTING
Occluder/cover lens option.
Set the occluder (cover lens).
• Primary occluder
Set the occlusion type to be controlled automatically by the program or operated by the
operator during the test. This set data is used as the initial value.
Selecting "Open (The operator must set it manually)" invalidates the occlusion con-
trolled automatically by the program. Use this setting when the operator decides a
fog power should be added to the occluded eye and sets it manually.
• Occluder
• +0.75D Lens
• +1.50D Lens
• +2.00D Lens
• Open; every time set by operator
• Occluder options available with [Shift] + Aux. Lens click.
Click the right mouse button for the auxiliary lens area, and you can change the occlusion
type to be used temporarily. When you perform this operation, place a check mark for the
selected type.
• Occluder
• +0.75D Lens
• +1.50D Lens
• +2.00D Lens
• Open; every time set by operator
Default
This button returns the system to the factory initial setting when shipped.
Page 1/Page 2
These buttons change the page for changing the setting.
OK/Cancel
Click the [OK] button. The new setting will be saved and the "Settings" menu appears
again.
Click the [Cancel] button. The new changes will be canceled and the "Settings" menu
appears again.
To Next Page
Loading...
Need help?
General
