7
MAINTENANCE
To ensure the safety and performance of this instrument, all maintenance work, unless specified in
this manual, shall be conducted by trained service engineers.
The following maintenance tasks may be performed by the user.
For details, see the relevant parts of this manual as specified below.
Replacing the face shield/forehead rest
The forehead rest and face shield on this instrument may be replaced by the user.
: Refer to " INSTALLING AND REMOVING THE FACE SHIELD AND FOREHEAD
REST" on P.38 for handling instructions.
Replacing the fuse
The fuses on this instrument may be replaced by the user.
: For details, refer to " REPLACING THE FUSE" on P.157.
Inspecting the instrument
It is recommended to inspect the mounting section of the CV-5000 and the system table peri-
odically to ensure they are attached properly.
: Refer to " INSPECTING THE MEASURING HEAD MOUNTING SECTION" on P.159.
ESCAPE CLAUSE
TOPCON shall not take any responsibility for damage due to fire, earthquakes, actions
by third persons and other accidents, or damage due to negligence and misuse by the
user and any use under unusual conditions.
TOPCON shall not take any responsibility for damage derived from inability to properly
use this instrument, such as loss of business profit and suspension of business.
TOPCON shall not take any responsibility for damage caused from using this instru-
ment in a manner other than that described in this user manual.
Diagnoses made shall be the responsibility of the user and TOPCON shall not take
any responsibility for the results of such diagnoses.
To Next Page
Loading...
Need help?
General
