Surveying with the HiPer+
1-866-4TOPCON www.topconpositioning.com
3-17
If using a Pacific Crest PDL (UHF) external modem,
follow these steps to configure this modem:
14. When finished with the previous steps, press the
power button on the external modem.
15. Select the radio transmission power using the Low/
High toggle on the rear panel of the modem. When in
High, the AMP PWR LED will be on.
16. Use the Channel button to set the frequency channel.
Check that the modem transmits the corrections (the
TX LED will blink red each time data transmits).
For more details on the settings available for configuring
the Base station, refer to the PC-CDU User’s Manual.
Setting up an RTK Rover
Use the following steps to set up an RTK Rover station.
You should already have programmed the modem.
Figure 3-11 on page 3-18 shows the hardware setup for a
Rover station with an external controller.
To Next Page
Loading...
