Operation
Topcon HiPer+ Operator’s Manual
4-20
Changing Receiver Modes
The HiPer+ receiver has four modes, two information modes and
two power modes:
•Normal Mode
• Extended Information Mode
• Sleep Mode
• Zero Power Mode
See “Information Modes” on page 4-7 for a description of
Normal Mode and Extended Information Mode.
Sleep Mode
In sleep mode, the power board and Bluetooth module will
continue to draw power from the batteries, causing the
batteries to drain over time. Put the receive in Zero Power
Mode to prevent this (see “Zero Power Mode” on page 4-20).
Follow these steps to put the HiPer+ into sleep mode.
1. Turn on your receiver.
2. Press the receiver’s power key for more than four
seconds and less than eight seconds. The STAT LED will
be orange. The receiver enters Sleep Mode.
3. Any activity on the RS232 port will turn the receiver on.
NOTICE
If you press the power key for more than 14
seconds, it will be ignored. This protects
receiver operation against stuck keys.
Zero Power Mode
When your HiPer+ is off, even in Sleep Mode, the power
board will continue to draw power from the batteries. This
means that if you fully charge your receiver, turn it off and
store it, the receiver will drain its battery power in less than
two months. To stop the power board and Bluetooth module
To Next Page
Loading...
