Topcon HiPer Plus - Enable and Apply Power Settings

Configuration
Topcon HiPer+ Operator’s Manual
2-20
• External – displays the external power supply’s voltage.
• On Board – displays the voltage drawn by the receiver
board.
• Battery A – displays the voltage of battery A.
• Battery B – displays the voltage of battery B.
• Charger – displays the charger’s output voltage during
battery charging.
8. Select and check each of the Turn on/off Slots check
boxes to enable the corresponding internal slots
(Figure 2-19).
9. Select and check the Enable Low Power Mode check box
to put the receiver’s processor into low power
consumption mode (Figure 2-19).
Figure 2-19. Enable and Apply Power Settings
10. Click Apply.