Chapter 2
1-866-4TOPCON www.topconpositioning.com
2-1
Configuration
This chapter describes:
• HiPer+ power supply
• Connecting the receiver and a computer
• HiPer+ configuration
• Minimum INTERface (MINTER) configuration
• Radio configuration
• Bluetooth module configuration
• Collecting almanacs
Before you can use your HiPer+ receiver, you need to:
1. Charge the batteries. See “Powering the HiPer+” on
page 2-2.
2. Configure the various parts of your receiver. See:
• “Connecting the HiPer+ and a Computer” on page 2-5,
• “HiPer+ Configuration” on page 2-10,
• “MINTER Configuration” on page 2-22,
• “Radio Configuration” on page 2-30 (if applicable), and
• “Bluetooth Module Configuration” on page 2-43.
3. Collect an almanac. See “Collecting Almanacs” on
page 2-49.
To Next Page
