Operation
Topcon HiPer+ Operator’s Manual
4-28
3. Select the Program tab and set the Capture Method to
Soft Break Capture (recommended) (Figure 4-24).
Figure 4-24. Program Tab Settings
4. Browse for and select the Bluetooth module’s RAM file
and Flash file (Figure 4-24).
5. Click Load and wait until 100% of the files load into
your receiver (Figure 4-25).
Figure 4-25. Bluetooth Firmware Load Complete
NOTICE
If you selected an incorrect RAM or Flash file,
an error message displays at the bottom of the
dialog box. Reselect the correct file.
6. Click File->Exit.
To Next Page
Loading...
