Connecting the HiPer+ and a Computer
1-866-4TOPCON www.topconpositioning.com
2-7
Establishing an RS232 Cable Connection
1. Using the RS232 cable, connect the serial port of your
computer (usually COM1) to the receiver’s serial port A.
2. Press the power buttons on the receiver and computer to
turn them on.
3. Continue with Step 1 in “Establishing a PC-CDU
Connection” on page 2-7.
Establishing a USB Cable Connection
Make sure you have installed Topcon’s USB driver (available
from http://www.topcongps.com/software/updates.html)
before continuing.
1. Using the USB cable, connect the USB port on the
receiver to a USB port on the computer.
2. Press the power buttons on the receiver and computer to
turn them on.
3. Continue with Step 1 in “Establishing a PC-CDU
Connection” on page 2-7.
Establishing a PC-CDU Connection
PC-CDU is a Personal Computer-Control Display Unit
software used to manage the various functions of your
receiver. The full range of PC-CDU configuration and
function is outside the scope of this manual. For more
information on any of the procedures in this section or on
PC-CDU, refer to the PC-CDU User’s Manual available on
the TPS website.
To Next Page
Loading...
