Receiver Problems
1-866-4TOPCON www.topconpositioning.com
5-3
Receiver Problems
The following are some of the most commonly encountered
receiver problems.
Problem
The receiver cannot establish a connection to a computer or
external controller.
Causes Solutions
The receiver’s Port B
has been disabled,
preventing wireless
communication
between the HiPer+
and a Bluetooth-
enabled external
device.
1. Connect your receiver and a
computer using an RS232 cable
(see “Establishing an RS232 Cable
Connection” on page 2-7).
2. Click Configuration->Receiver
->General.
3. In the Turn on/off Slots area,
enable the Slot 3 (B) check box.
The Daisy Chain mode
is still active.
See Step 14 on page 2-38 for the
procedure to turn off the Daisy Chain.
The cable is not
properly plugged in.
• Check that the cable connector is
attached to the correct serial port.
• Unplug the cable, then securely and
properly reconnect it to the receiver.
• See “External Components” on
page 1-14 and “Connector
Specifications” on page B-10 for
information on the receiver’s
connectors.
The cable is damaged. • Use an undamaged cable.
• Contact your Dealer to purchase new
cables.
To Next Page
Loading...
