Loading New Firmware
1-866-4TOPCON www.topconpositioning.com
4-23
Loading New Firmware
Base and Rover receivers must be loaded with the same firmware
version. Use the latest firmware version, available for download
from the TPS website, to ensure your receiver has access to the
most recent updates.
The receiver board and power board must be loaded with
firmware from the same package. The Bluetooth module’s
firmware is independent of the receiver card and power board,
and has a different firmware package.
The HiPer+ uses FLoader, a Windows®-based utility, to load
firmware onto the receiver and power boards. You can download
FLoader to your computer from the TPS website. For more
information, refer to the FLoader User’s Manual, also available
on the TPS website.
1. Download and install FLoader, if applicable.
2. Download and unzip the new firmware package(s) to your
computer.
3. Connect your receiver and computer. See “Connecting the
HiPer+ and a Computer” on page 2-5 for this procedure.
4. Activate FLoader (Figure 4-18).
Figure 4-18. FLoader Main Screen
5. On the Connection tab, select the COM port on your
computer that connects with your receiver and select its
speed (usually 115200) (Figure 4-18).
To Next Page
Loading...
