Topcon HiPer Plus - Creating Scripts

Creating Scripts
Topcon HiPer+ Operator’s Manual
A-2
8. Type in the appropriate commands, and press Enter after
each one. See Table A-1 for these commands.
9. Click Save script.
10. Click Close editor.
Once you have created a script file,
1. Click Load script on the Manual Mode dialog box.
2. Navigate to the folder that contains your script file.
3. Select the appropriate script file and click Open.
4. Press Enter or click Send command to run the script file.
Table A-1. Script Commands
To Create Daisy Chain To End Daisy Chain
%%set,dev/ser/c/rate,38400
%%set,dev/ser/c/echo,/cur/term
%%set,dev/ser/c/imode,echo
%%set,cur/term/eoff,QUIT
%%set,cur/term/echo,/dev/null
%%set,cur/term/imode,echo
%%set,cur/term/echo,/dev/ser/c
QUIT
%%set,cur/term/imode,cmd
%%set,dev/ser/c/echo,/dev/null
%%set,dev/ser/c/imode,cmd
%%set,dev/ser/c/rate,38400
%%set,cur/term/rate,115200