Topcon HiPer Plus - Data Recording Parameter Behavior

MINTER Configuration
1-866-4TOPCON www.topconpositioning.com
2-29
Also, if Always is enabled, your receiver will automatically
start logging data (to a newly created or an existing file) in
the following three cases:
• After pressing the MINTER power key.
• After resetting the receiver (with PC-CDU or the Reset
key).
• After taking the receiver out of Sleep Mode.
Table 2-1. Data Recording Parameter Behavior
Before
Power
Failure
Enabled Radio Button Results
Off On Always
1
Receiver
data logged
to file
specified.
Data logging will
not resume when
power is restored.
Receiver will
resume data
logging to the
same file when
power is restored.
Receiver will
resume data
logging to the
same file when
power is restored.
2
Receiver
data logged
to default
file.
Data logging will
not resume when
power is restored.
A new log file
will open when
power is restored
and data will log
to this file.
A new log file
will open when
power is restored
and data will log
to this file.
3
File
specified;
receiver data
logging not
started.
No file will open
with this name.
Data logging will
not start when
power is restored.
No file will open
with this name.
Data logging will
not start when
power is restored.
A log file with
this name will
open and data
logging will start
after power is
restored.
4
No file
specified;
receiver data
logging off.
Data logging will
not start when
power is restored.
Data logging will
not start when
power is restored.
A log file with a
default name will
open and data
logging will start
after power is
restored.