Operation
Topcon HiPer+ Operator’s Manual
4-8
In EIM, the STAT LED blinks seven times per cycle.
Each blink could be orange, red, or green.
• Orange – information for test unavailable.
• Green – receiver passed the test.
• Red – receiver failed the test.
1. To switch to EIM, press and quickly release (within
one second) the FN key on the MINTER.
2. Watch for the delimiter double-blink. With good
receiver, antenna, and observation conditions, all
blinks should be green within 15 minutes of
powering on.
• Green – ok
•Orange – wait
• Red – some tests failed
3. To switch back to normal, press the FN key.
Downloading Files to a Computer
When your survey finishes, you can download your survey files
to a computer for storage, post-processing, or backup. Also, the
HiPer+ memory holds a finite amount of files and information, so
downloading the files to your computer ensures that no files are
lost.
You should download files as soon as possible after collecting
data at the jobsite. PC-CDU provides a File Manager to
download files to your computer and delete files from the HiPer+.
1. Connect your receiver and computer. See “Connecting the
HiPer+ and a Computer” on page 2-5 for this procedure.
AND
Enable RTS/CTS handshaking (Figure 4-2 on page 4-9).
To Next Page
Loading...
