Operation
Topcon HiPer+ Operator’s Manual
4-24
See the following sections to load the appropriate firmware.
Receiver and Power Board Firmware
Receiver and power board firmware is released as a
compressed file that you download and decompress. This file
contains the following three files:
• ramimage.ldr – the Receiver board RAM file
• main.ldp – the Receiver board Flash file
• powbrd.ldr – the Power board RAM file
NOTICE
You must load all three files when loading new
firmware. These files must come from the same
firmware package.
1. In FLoader, select the Device tab and set the Device
Type as Receiver (Figure 4-19).
Figure 4-19. Get Device Type
2. Click Get from Device for device information
(Figure 4-19).
To Next Page
Loading...
