Operation
Topcon HiPer+ Operator’s Manual
4-2
Power Key
Pressing the power key turns the receiver on and off.
Status LED
• When the receiver is on and no satellites are tracked, the
STAT LED will blink red.
• When satellites are tracked, the STAT LED will produce
one blink for each tracked satellite (green for GPS,
orange for GLONASS).
Reset Key
Pressing the reset key for about one second causes:
• a hard reset of the receiver.
• the receiver to leave Zero Power Mode and return to
Normal Mode.
NOTICE
Only use this procedure if the receiver does
not respond to commands or does not charge
the internal batteries (is in Zero Power Mode).
FN Key and Record LED
Table 4-1 on page 4-4 summarizes FN key functions and
REC LED statuses. See “FN Key Mode parameter” on
page 2-28 for information on setting FN key modes.
• Pressing the FN key for less than one second switches
the receiver between different information modes
(normal and extended information), or between static and
dynamic post-processing modes, depending on the
receiver's configuration.
During the first second of pressing the FN key, the REC
LED is orange.
• Pressing the FN key for more than one and less than five
seconds will start/stop data recording.
To Next Page
Loading...
