Bluetooth Problems
1-866-4TOPCON www.topconpositioning.com
5-9
Bluetooth Problems
The following are some of the most commonly encountered error
messages. BTCONF reports the error messages in the status bar.
Error Message
Can’t find receiver.
Causes Solutions
The receiver is turned
off.
Ensure the receiver has power and is
turned on.
The cable’s connectors
are improperly
attached.
• Check that the cable connector is
attached to the correct serial port.
• Unplug the cable, then securely and
properly reconnect it to the receiver.
The cable is damaged. • Use an undamaged cable.
• Contact your Dealer to purchase a
new cable.
The COM port the
receiver is attached to
differs from the one
selected in BTCONF.
Ensure that the RS232 cable is attached
to the COM port specified in the
BTCONF communication port drop-
down list. See “Bluetooth Module
Configuration” on page 2-43 for
details.
The receiver port used
for connection is not in
Command mode.
1. Connect your receiver and a
computer using a free port (see
“Connecting the HiPer+ and a
Computer” on page 2-5) and start
PC-CDU.
2. Click Configuration->Receiver
->Ports.
3. Change the Input for the serial port
used for connection to Command.
To Next Page
Loading...
