MINTER Configuration
1-866-4TOPCON www.topconpositioning.com
2-23
The MINTER allows the user to perform numerous functions:
• Turn the receiver on or off, put it in Sleep mode or Zero
power mode.
• Turn data recording on or off (FN key).
• Change the receiver’s information mode.
• Show the number of GPS (green) and GLONASS (orange)
satellites being tracked (STAT led).
• Show data recording status (REC led).
• Show each time data is recorded to internal memory (REC
led).
• Show the status of post-processing mode (static or dynamic)
when performing a Post-Processing Kinematic survey with
the help of FN key (REC LED).
• Show the status (high charge, intermediate charge, or low
charge) of the battery (BATT LED).
• Show the power source for the HiPer+ (BATT LED).
• Show the status of the modem and if it receives signals (RX
LED).
You use PC-CDU to configure MINTER settings. Refer to the
PC-CDU User’s Manual for other possible MINTER
configurations.
1. Connect your receiver and computer. See “Connecting the
HiPer+ and a Computer” on page 2-5 for this procedure.
AND
Enable RTS/CTS handshaking (Figure 2-21 on page 2-24)
To Next Page
Loading...
