Universal Robots UR16e

(A) Separator
Wizard
1. Tap the Separator Action node on the Program Tree.
2. On the Separator Action screen, tap Next.
3. Tap the Move Here button and hold the Auto button or use the
Manual button to move the robot to the Separator Point. Tap the
Continue button. Tap Next.
4. Tap Set Waypoint to teach the Approach Waypoint (see ). Tap Next.
5. Repeat Step 3.
6. Tap Set Waypoint to teach the Exit Waypoint (see ). Tap Next.
7. Tap Finish.
8. You can now add appropriate action nodes in the Pick Up Separator,
Drop Off Separator, and Tool Action folders in the Program Tree.
(B) Manual
Configuration
1. Tap the Separator Action node on the Program Tree.
2. On the Separator Action start screen, tap Manual Configuration.
3. Move the robot to the Separator Point by tapping Move to Separator
Point.
4. Tap the Approach node in the Program Tree to teach the robot the
Approach Waypoint (see ).
5. Tap the Separator Action node in the Program Tree. Repeat Step 3.
6. Tap the Exit node in the Program Tree to teach the robot the Exit
Waypoint (see ).
7. You can now add appropriate action nodes in the Pick Up Separator,
Drop Off Separator, and Tool Action folders in the Program Tree.
Options to
Customize A
Palletizing Program
You can customize your palletizing program in the following ways:
•
If your pallet needs to be adjusted or re-positioned after you have
created a palletizing program, you only need to re-teach the pallet
Feature (see ) because the palletizing sequence is fixed relative to
the Feature. Thus, all other program components automatically
adjust to the newly taught position.
•
You can edit the properties of the move commands (see ).
•
You can change the speeds and blends radii (see ).
•
You can add other program nodes to the At Each Item sequence or
the Separator Action sequence.
User Manual 263 UR16e
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.