Universal Robots UR16e

Example:
Dynamically
Updating a Feature
Pose
Consider a similar application where the robot must move in a specific
pattern on top of a table to solve a particular task.
A MoveL command with four waypoints relative to a plane feature
Robot Program
MoveJ
wp1
y = 0.01
o = p[0,y,0,0,0,0]
P1_var = pose_trans(P1_var, o)
MoveL # Feature: P1_var
wp1
wp2
wp3
wp4
54.3: Applying an offset to the plane feature
54.4:
Robot Program
MoveJ
S1
if (digital_input[0]) then
P1_var = P1
else
P1_var = P2
MoveL # Feature: P1_var
wp1
wp2
wp3
wp4
54.5: Switching from one plane feature to another
54.6:
The movement relative to P1 is repeated a number of times, each time by
an offset o . In this example the offset is set to 10 cm in the Y-direction,
offsets O1 and O2 ). This is achieved using pose_add() or pose_trans()
script functions to manipulate the variable. It is possible to switch to a
different feature while the program is running instead of adding an offset.
This is shown in the example. See the figure where the reference feature
for the MoveL command P1_var can switch between two planes P1 and
P2 .
User Manual 313 UR16e
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.