Residual heat mode
In the Start mask, a flashing heater symbol in a
circle
in the menu bar and the current status of
the heater are displayed.
In the residual heat mode, the heating system uses
the residual heat in the coolant circuit of the warm
engine and distributes heated air in the cab.
In this operating mode, only the water pump and fan
are in operation.
NOTE!
Residual heat mode cannot be used if the coolant
temperature is too low.
Residual heat mode ON
- Press the operating button and select ON.
– Residual heat mode starts if there is residual
heat in the engine coolant.
– The LED ring lights up orange. The operating
time of the heating mode depends on the
available residual heat.
– The operating status and mode of the heater
appear on the display.
Residual heat mode OFF
- Press the operating button and select OFF.
– Residual heat mode stops.
NOTE!
LONGPRESS stops the residual heat mode
immediately.
Start mask, residual heat
Residual heat mode ON
154
Other controls
Operator comfort
To Next Page
Loading...
