Hydraulic oil
- Interval: This shows the value of hydraulic oil
interval in the unit hours. The operator can
adjust the hydraulic oil interval. The setting
range is 100 ~ 5000 hours.
- Time remaining: This shows the value for
remaining time to next hydraulic oil service.
When the "Time remaining" reaches 40 h, 20
h, and 0 h, the check screen with "Time
remaining" and "Interval" will pop up on the IC
(Instrument Cluster). Service the maintenance
items which should be serviced in that interval.
For the service interval and maintenance
items, see page
367
.
- Reset time remaining?: After servicing the
maintenance items, the time can be reset.
Press ESC button to "Cancel " or SELECT
button to "Yes". When the time is reset, the
next service interval and "Time remaining" will
be displayed.
If operator does not maintain the parts and
reset this value it turns to zero and then to
negative.
- Hammer op. hours: This shows the counted
value of hammer operating time in the unit
hours. “Hammer op. hours” is not adjustable.
It is automatically reset to zero when “Time
remaining” is reset and shows the hammer
operating hours from the reset point.
V1137883
Service
Hydraulic oil
1500h
Hydraulic oil
Interval: 2000h
Set interval
Hydraulic oil
Set interval:
2000h
V1137884
Hydraulic oil
Time remaining: 1500h
V1140746
Reset time remaining?
Yes
V1137885
Hydraulic oil
Hammer Op hours:
Instrument panels
Display unit
53
To Next Page
Loading...
