Hydraulic oil filter
- Interval: This shows the value of hydraulic oil
filter interval in the unit hours. The operator
can adjust the hydraulic oil filter interval. The
setting range is 100 ~ 2000 hours.
- Time remaining: This shows the value for
remaining time to next hydraulic oil filter
service.
When the "Time remaining" reaches 40 h, 20
h, and 0 h, the check screen with "Time
remaining" and "Interval" will pop up on the IC
(Instrument Cluster). Service the maintenance
items which should be serviced in that interval.
For the service interval and maintenance
items, see page
367
.
- Reset time remaining?: After servicing the
maintenance items, the time can be reset.
Press ESC button to "Cancel " or SELECT
button to "Yes". When the time is reset, the
next service interval and "Time remaining" will
be displayed.
If operator does not maintain the part and reset
this value it turns to zero and then to negative.
- Hammer op. hours: This shows the counted
value of hammer operating time in the unit
hours. “Hammer op. hours” is not adjustable.
It is automatically reset to zero when “Time
remaining” is reset and shows the hammer
operating hours from the reset point.
V1137886
Service
1500h
Hydraulic oil filter
Hydraulic oil filter
Interval: 2000h
Set interval
Hydraulic oil filter
Set interval:
2000h
V1137887
Hydraulic oil filter
Time remaining: 1500h
V1140746
Reset time remaining?
Yes
V1137888
Hydraulic oil filter
Hammer Op hours:
54
Instrument panels
Display unit
To Next Page
Loading...
