WILLTEK 4403 - Page 375

Appendix A SCPI Command Reference
MEASure subsystem
WCDMA Options Version 6.20
353
:MEASure:WCDMa:ARRay:RFTX:QMA
:MEASure:WCDMa:ARRay:RFTX:CODedomain:PCDe
:MEASure:WCDMa:ARRay:RFSPectrum:MSPectrum:OBW
:MEASure:WCDMa:ARRay:RFSPectrum:ACLR
Syntax
:MEASure:WCDMa:ARRay:RFTX:QMAX
Parameters
Int1 is an integer. The minimum value for Int1
is 0, the maximum value is 100.
The default value is 0.
Description
It starts UE power measurements at maximum levels and it returns an array of Int1
measurement values.
Query
The query form of this command will perform the measurement Int1 and return the
result values. The result delivered will contain an array of floating point numbers.
Example
:MEASure:WCDMa:ARRay:RFTX:QMAX? 10
Syntax
:MEASure:WCDMa:ARRay:RFTX:QMAX
Parameters
Int1 is an integer. The minimum value for Int1
is 0, the maximum value is 100.
The default value is 0.
Description
Performs an peak code domain error measurement as many times as specified.
Query
The query form of this command will perform the measurement the specified number
of times, and return the results.
Example
:MEAS:WCDM:ARR:RFTX:COD:PCD? 10
Syntax
:MEASure:WCDMa:ARRay:RFSPectrum:MSPectrum:OBW
Parameters
There are no parameters.
Description
Performs an occupied bandwidth measurement as many times as specified. To read
out the latest measurement result use the FETC:WCDM:RFSP:MSP:OBW
command.
Query
The query form of this command will perform the measurement the specified number
of times, and return the results.
Example
:MEAS:WCDM:ARR:RFSP:OBW? 15
Syntax
:MEASure:WCDMa:ARRay:RFSPectrum:ACLR <int1>
Parameters
int1
is an integer.
The minimum value for
int1 is 0, the maximum value is 100. The default value for
int1
is 0.
Description
Performs the measurement of the ACLR modulation spectrum a specific number of
times (set with the int1 parameter).