WILLTEK 4403 - Page 391

Appendix A SCPI Command Reference
FETCh Subsystem
WCDMA Options Version 6.20
369
:FETCh:WCDMa:RFTX:MODQuality:IQOFfset?
:FETCh:WCDMa:RFTX:MODQuality:IQIMbalance?
:FETCh:WCDMa:RFTX:INNErloop[:DATA]?
:FETCh:WCDMa:RFTX:QMAX[:DATA]?
Syntax
:FETCh:WCDMa:RFTX:MODQuality:IQOFfset?
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
The command returns the result of a previous
:MEASure:WCDMa:CONT|ARR:RFTX:MODQuality:IQOFfset measure-
ment command
.
Example
:FETC:WCDM:RFTX:MODQ:IQOF?
Returns the origin offset in dBc, e.g.
-28.251.
Syntax
:FETCh:WCDMa:RFTX:MODQuality:IQIMbalance?
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
The command returns the result of a previous
:MEASure:WCDMa:CONT|ARR:RFTX:MODQuality:IQIMbalance
mea-
surement command.
Example
:FETC:WCDM:RFTX:MODQ:IQIM?
Returns the IQ imbalance in dBc, e.g.
-43.743.
Syntax
:FETCh:WCDMa:RFTX:INNErloop[:DATA]?
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
The query form returns the result of a previous
:MEASure:WCDMa:RFTX:INNErloop[:STARt] measurement. The result
delivered will contain two times as many floating-point numbers in dBm as defined
within the TPC sequence. Each result is followed by a calculated error value.
Example
:FETC:WCDM:RFTX:INNE[:DATA]?
Returns the result in a string, e.g. -54.9,0.2,-62.7,-0.3,-61.3,0.1
.
Syntax
:FETCh:WCDMa:RFTX:QMAX[:DATA]?
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
The query form returns the result of a previous
:MEASure:WCDMa:ARRay:RFTX:QMAX? 3 measurement.