2 Install the bearing shell.
2.1 Remove carefully the engine room crane from the lifting tool (002).
2.2 Operate carefully the chain block (001) to lower the bearing shell (003) on to the
crankshaft.
2.3 Remove the chain block (001) and the lifting tool (002).
2.4 Put the wire ropes (006) of the turning-out device (006, Figure 6-14) over the
bearing shell (002) and under the crankshaft.
2.5 Attach the wire ropes of the device (009) to the lifting plate (008).
2.6 Attach the chain block (004) to the lifting plate (008).
2.7 Operate carefully the chain block (001) to move the bearing shell (002) into the
bearing girder on the fuel side.
2.8 Make sure that the bearing shell (002) is level.
2.9 Remove the lifting plate (008) and the device (009).
2.10 Attach the bearing shell (002) with the four Allen screws (007).
X62DF
AA00-1134-00AAA-720A-A
Maintenance Manual Main bearing shell - install
Winterthur Gas & Diesel Ltd.
- 128 - Issue 002 2020-10
To Next Page
Loading...
