WinGD X62DF - Pilot Injection Valve - Do a Functional Test

7.10.4 Pilot injection valve - do a functional test
Periodicity
Description
Working hours 12 000
Duration for performing preliminary requirements 0.0 man-hours
Duration for performing the procedure 1.0 man-hours
Duration for performing the requirements after job completion 0.0 man-hours
Personnel
Description Specialization QTY
Engine crew Basic AR
Support equipment
Description Part No. CSN QTY
Test bench 94272 1
HP hose 94275 1
Valve holder 94273 1
Supplies
Description QTY
Test fluid, ISO 4113 A/R
Spare Parts
Description Part No. CSN QTY
None
SAFETY PRECAUTIONS
WARNING
Danger: Do not put your fingers near the nozzle tip. Fuel can go through your skin and
cause injury or kill You.
WARNING
Injury Hazard. Test fluid is dangerous. Always read the manufacturer’s safety
instructions before you use test fluid.
NOTE: Only trained personnel are permitted to do this procedure.
NOTE: If test fluid is not available, you can use clean diesel oil. If you use clean diesel oil,
install the injection valve immediately on the engine after you have completed this
procedure.
NOTE: It is not recommended that diesel oil is used if the injection valve is put into storage
after this procedure. Diesel oil can cause corrosion of the injection valve.
X62DF
AA00-2790-00AAA-362A-A
Maintenance Manual Pilot injection valve - do a functional test
Winterthur Gas & Diesel Ltd.
- 336 - Issue 002 2020-10