Fig 8-29 Bottom end bearing
3.11 Attach the shackles (001, Figure 8-30) to the column.
3.12 Attach the shackles (005) to the shackles (001).
3.13 Attach the lever chain hoists (002) to the shackles (005).
3.14 Attach the console frame (004) to the bearing shell (008) with the four screws
(006).
3.15 Attach the lever chain hoists (002, 005) to the console frame (004).
3.16 Operate the lever chain hoists (002) to apply a light tension on their chains
(003).
3.17 Remove the two screws (007).
3.18 Operate the lever chain hoists (002) to lower the console frame (004) together
with the bearing shell (008).
3.19 Attach the chain block (010) to the eyelet on the console frame (004).
3.20 Operate the chain block (010) and the lever chain hoists (002) to move the
console frame (004) through the column door.
3.21 Remove the lever chain hoists (002).
3.22 Operate the chain block (010) to lower the console frame (004) on to an
applicable surface.
3.23 Remove the chain block (010).
3.24 Remove the console frame (004).
X62DF
AA00-3303-03AAA-520A-A
Maintenance Manual Connecting rod - remove the bottom end bearing
Winterthur Gas & Diesel Ltd.
- 405 - Issue 002 2020-10
To Next Page
Loading...
