WinGD X62DF - HP Fuel Pipe - Completion

PROCEDURE
1 Remove the clamps (015 and 016, Figure 13-13).
2 Remove the four screws (002) from the flange (003).
Fig 13-13 HP fuel pipes - remove and install
00565
FUEL SIDEDRIVING END
III
I - I
I
I
III
II
II
002
005
007
003
015
016
001
012
013
014
II - II
006
009
004
010
001
008
008
011
3 Carefully move the flange (003) away from the valve housing (004).
4 Remove the four screws (005) from the flange (006).
5 Loosen the two screws (011).
6 Carefully move the flange (006) away from the intermediate piece (010).
7 Carefully remove the HP fuel pipe (001).
8 Apply protection to the sealing faces to prevent damage and contamination.
9 Remove the four screws (007) from the flange (009).
10 Carefully move the flange (009) away from the intermediate piece (010).
11 Remove the four screws (012) from the flange (013).
12 Carefully move the flange (013) away from the intermediate piece (010).
13 Carefully remove the HP fuel pipe (008).
14 Apply protection to the sealing faces to prevent damage and contamination.
CLOSE UP
• None
X62DF
AA00-8752-00AAA-520A-A
Maintenance Manual HP fuel pipe (fuel pump to fuel rail) - remove
Winterthur Gas & Diesel Ltd.
- 755 - Issue 002 2020-10