PROCEDURE
1 Prepare the crosshead before removal:
1.1 Remove the toggle lever (001, Figure 8-47) from the crosshead pin (002). Let
the toggle lever hang in the column.
Fig 8-47 Toggle lever - remove
NOTE: THE CRANK SHAFT IS AT BDC
001
002
00757
1.2 Remove the round nuts from the elastic studs on the connecting rod, refer to
section 4.3 Loosen a round nut with a pre-tensioner.
1.3 Make sure that the platforms is installed.
1.4 Put protection on the oil inlets of the crosshead pin to prevent damage and
contamination.
1.5 Disconnect the electrical connection from the temperature sensor (002, Figure
8-50).
1.6 Remove the temperature sensor (002).
X62DF
AA00-3326-00AAA-520A-A
Maintenance Manual Crosshead - remove
Winterthur Gas & Diesel Ltd.
- 446 - Issue 002 2020-10
To Next Page
Loading...
