14.7 Turn the rod (001) back to release the tension in the spring (006). Make sure
that the valve cotter (003) is installed correctly in the spring carrier (012).
14.8 Remove the dismantling and assembling tool and the bracket from the bush
(007).
15 Do the test procedure given in Step 3 to Step 11 again.
16 If the leakage is unsatisfactory, replace the valve spindle and valve guide.
CLOSE UP
• None
X62DF
AA00-2140-00AAA-362A-A
Maintenance Manual Gas admission valve - do a check for gas leakage
Winterthur Gas & Diesel Ltd.
- 213 - Issue 002 2020-10
To Next Page
Loading...
