PROCEDURE
1 Apply clean oil to the 2-part gaskets (002, Figure 8-10) and the 2-part gasket (001).
2 Install the 2-part gaskets (002, 001). Make sure that the 2-part gaskets can move freely.
3 Attach the two shackles (003) to the platform.
4 Attach the two slings (004) to the shackles (003).
5 Attach the link (005) to the two slings (004).
6 Attach the spur-geared chain-block (006) to the link (005).
7 Attach the two eye bolts (008) to the top cylinder half.
8 Attach the chain (007) to the eye bolts (008).
9 Attach the engine room crane (010) to the chain (007).
10 Operate the engine room crane (007) to lift and move the top cylinder half (009) into
position above the bottom cylinder half.
11 Attach the chain block (006) to the chain (007).
12 Operate the chain block (006) to hold the weight of the top cylinder half (009).
13 Remove the engine room crane (010) from the chain (007).
14 Operate carefully the chain block (006) to lower the top cylinder half (009) on the bottom
cylinder half.
NOTE: When you do this step, make sure that you do not cause damage to the 2-part
gaskets (001, 002).
X62DF
AA00-3140-00AAA-710A-A
Maintenance Manual Axial vibration damper - assemble
Winterthur Gas & Diesel Ltd.
- 367 - Issue 002 2020-10
To Next Page
Loading...
