15 Make sure that the holes in the bearing cover (005) engage with the four dowel pins
(009).
16 Remove the chain blocks (002, 006), chain (004), shackles (001, 003) and eye bolts.
17 Install the four round nuts (008) to the elastic bolts (007), refer to section 4.2 Tighten a
round nut with a pre-tensioner.
X62DF
AA00-3303-01AAA-720A-A
Maintenance Manual Connecting rod - install the top end bearing cover
Winterthur Gas & Diesel Ltd.
- 428 - Issue 002 2020-10
To Next Page
Loading...
