5 Attach the applicable chain (001 or 004) to the shackles (005).
6 Attach the chain block (002) to the chain (001 or 004).
7 Operate the chain block (002, Figure 8-42) to lift the connecting rod (001) to sufficient
height.
8 Attach the chain block (007) to the connecting rod (001).
9 Operate the chain blocks (002, 007) to move the connecting rod (001) into the position
shown in view C.
10 Attach the lever chain hoist (004) to the lug (005).
11 Attach the chain block (008) to the plate (006).
12 Operate the chain block (880) to lift the plate (006) up to the crosshead.
13 Attach the plate (006) to the rod with the two bolts and nuts.
14 Remove the chain block (008) from the plate (006).
15 Remove the lever chain hoist (003).
X62DF
AA00-3303-00AAA-720A-A
Maintenance Manual Connecting rod - install
Winterthur Gas & Diesel Ltd.
- 435 - Issue 002 2020-10
To Next Page
Loading...
