PROCEDURE
1 Remove the screws from the cover of the supply unit.
2 Remove the cover from the supply unit.
3 Do a check of the pinions and of the camshaft gear wheel for wear and damage.
4 Compare the value for clearance with the value given in section 3.3 Clearances -
general.
5 If there is too much wear and / or damage, you must replace the pinions and the
camshaft gear wheel.
6 Attach the cover to the supply unit casing withe the screws.
CLOSE UP
• None
X62DF
AA00-5551-00AAA-320A-A
Maintenance Manual Servo oil pump - do a check for wear and damage
Winterthur Gas & Diesel Ltd.
- 531 - Issue 002 2020-10
To Next Page
Loading...
