WinGD X62DF - Page 677

PROCEDURE
1 Remove the cover (011, Figure 12-3) from the rail unit for access.
NOTE: The figure is for MK-E pump. For MK-1 pump the pump and the pipes are
partly different.
2 Put a drip tray under the pipes (001, 003, 004).
3 Put marks on the pipes (001, 003, 004) to identify them.
4 Remove the pipes (001, 003, 004).
5 Remove the pipe brackets (005).
6 If necessary, remove the pipe brackets (006).
7 Disconnect the electrical connection from the 4/2-way valve (010).
8 Disconnect the electrical connection from the pressure transmitter (007).
9 Put a drip tray under the pipes (008).
NOTE: The number of pipes is related to the engine.
10 Remove the pipes (008).
11 Hold the weight of the cylinder lubricating pump (009).
12 Remove the screws (002).
13 Remove the cylinder lubricating pump (009).
14 To replace the 4/2-way valve (010), do as follows:
NOTE: You also can do this step if the cylinder lubricating pump is installed.
14.1 Remove the related screws of the 4/2-way valve (010).
14.2 Remove the 4/2-way valve (010).
14.3 Put the new 4/2-way valve (010) in position.
14.4 Make sure that the O-rings are in position.
14.5 Torque the screws of the 4/2-way valve (010) with 9 Nm.
X62DF
AA00-7206-00AAA-520A-A
Maintenance Manual Cylinder lubricating pump - remove
Winterthur Gas & Diesel Ltd.
- 677 - Issue 002 2020-10