PROCEDURE
1 Operate the turning gear to get the crank angle mark (003, Figure 14-3) of the flywheel
(001) opposite the applicable proximity sensor (005).
2 Put a mark on the applicable cable to identify its position.
3 Disconnect the applicable electrical connection from the proximity sensor (005).
4 Loosen the locknut (002).
5 Remove the proximity sensor (005) from the holder (004).
X72DF
AA00-9223-00AAA-520B-A
Maintenance Manual Crank angle sensor unit (flywheel) - remove the proximity sensor
Winterthur Gas & Diesel Ltd.
- 787 - Issue 002 2020-10
To Next Page
Loading...
Need help?
General
