PROCEDURE
1 Install the IOM-10.
2 Connect the power supply to the IOM-10.
3 After a reboot of the IOM-10, the ECS activates a software download.
NOTE: You can monitor the software download on the IOM-10 at the local control
panel..
4 If applicable, start the engine at the remote control system (RCS), refer to the Operation
Manual.
NOTE: The engine will do a standard start.
CLOSE UP
• None
X62DF
AA00-9606-00ADA-720A-A
Maintenance Manual IOM-10 - install
Winterthur Gas & Diesel Ltd.
- 819 - Issue 002 2020-10
To Next Page
Loading...
