04/2016
1-4
Phaser 4600/4620/4622 Printer Service Manual
SCP 1, SCP 2
Revised
1 Service Call Procedures
SCP 1 Initial Actions
Initial Actions are used to gather information on the machine performance
Start a service call with SCP 1 and end with SCP6 Final Actions.
Also refer to SCP 7 Configurations and Options.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Do not work in a confined space. 1m (39 inches) space is needed for safe working.
NOTE: Ignore any references in this manual to options not installed on the machine.
1. Take note of symptoms or error messages.
2. Ask the operator to describe or demonstrate the problem.
3. Make sure that:
a. The power cord is connected to the wall outlet and to the machine.
b. Paper is loaded correctly and all paper trays and covers are closed
c. If installed, the USB cable or network connection is installed correctly.
4. If available, check the machine service log book for any previous actions that may be rel-
evant to the call.
5. If this is the first service call to this machine perform SCP 2 First Call Actions, otherwise
go to SCP 3 Normal Call Actions.
SCP 2 First Call Actions
First Call Actions are used for the first service call.
Procedure
1. Check the machine configuration with the customer, refer to SCP 7 Machine Configura-
tions and Options. Check that all required hardware and software is installed and/or
enabled.
2. Check that all the relevant machine settings are correctly entered, refer to GP 4 System
Administration Tools.
3. If a fault is present, go to SCP 3 Normal Call Actions. If there is no fault present, go to
SCP 6 Final Actions.
4. Enter the machine details and the customer details in the service log.
To Next Page
Loading...
Need help?
General
