Xerox Phaser 6120

Phaser® 6120 Color Laser Printer Service Manual
3-25
DATE & TIME
ENERGY SAVER
ENERGY SAVER MGT
SECURITY
CONFIG
ENABLE
Function Sets the TOD (time-of-day) clock on the hard drive.
Use
■ To adjust the TOD clock on the hard drive.
■ The settings appear in the following order: year, month, day:hour,
minutes, seconds.
Note: This menu item appears only if an optional hard drive installed.
Setting/procedure 1. Select “DATE & TIME.”
2. Using
▲, ▼, , and keys, enter the time-of-day, and day, month, and
year.
3. Accept the date and time setting using the Menu Select key.
Function Specifies the length of time before the machine enters Energy Saver mode
after the last print is received or the last key operated.
Use To set the amount of time before the machine enters Energy Saver mode.
Setting/procedure The default setting is 30 MINUTES.
15 MINUTES
30 MINUTES
1 HOUR
2 HOURS
* Displayed only on the 110 V models.
Note: This setting is available only when SYSTEM DEFAULT→
ENERGY
SAVER MGT is set to “ON.”
Function Sets whether the printer should go into Energy Saver mode when not printing
or processing a print job and when the Control Panel is not being used.
Use To specify whether Energy Saver mode is to be used.
Setting/procedure The default setting is ON.
ON/OFF
Note: This menu item is available only on the 110 V model.
Function Selects whether or not the menus are protected with a password.
Use To protect all menus with a password.
Setting/procedure The default setting is OFF.
ON/OFF
T
T