3-60 Phaser 8400/8500/8550 Color Printer
C2C Strip flag unexpected event during mechanical recovery.
C2D Strip flag unexpected state during warm-up.
C2E Strip flag unexpected event during printer ready.
C2F Strip flag unexpected event during fault.
C2K Strip flag unexpected event during transfix roller oiling.
C2M The strip flag actuated unexpectedly when paper picked from Tray 2.
C2N The strip flag actuated unexpectedly when paper picked from Tray 3.
C2P The strip flag actuated unexpectedly when paper picked from Tray 4.
C2Q The strip flag actuated unexpectedly when paper picked from Tray 1.
C2R Strip flag unexpected event during pick from the duplex path.
C2T Strip flag unexpected event during transfix.
1. Ensure ground integrity of the printer, see page 4-77.
2. Check the paper tray for overfill.
3. Run the Stripper sensor test.
4. Inspect the stripper blade for damage or debris.
5. Run the Paper Lead Edge Times test.
6. Replace the stripper carriage assembly.
C2X Strip flag unexpected event during exit.
1. Ensure the media is not too thick and that it is supported by the printer.
2. Use a less glossy media.
3. Ensure the guides in the tray are snug against the media.
4. If the drum maintenance unit is near the end of its life, replace it.
5. Clean and inspect the exit rollers.
6. Run the Paper Path Drive test.
C3M The strip flag timed out waiting for the paper picked from Tray 2.
C3N The strip flag timed out waiting for the paper picked from Tray 3.
C3P The strip flag timed out waiting for the paper picked from Tray 4.
C3Q The strip flag timed out waiting for the paper picked from Tray 1.
Jam Code Troubleshooting Procedures (Continued)
To Next Page
Loading...
Need help?
General