Xerox Phaser 8400 Service Manual

8-52 Phaser 8400/8500/8550 Color Printer
Examine the process gear drive train for the following:
■ The holes is the process drive frame must align with the holes in the gear.
■ The hole in the drum maintenance camshaft gear must align with the arrow on the
frame.
Caution
The hole in the transfix camshaft gear align with the hole on the frame.
Replacement gear boxes come with two pins to hold the gears in position.
Use either the pins that come with replacement gear boxes, or a paper clip,
bent into a U shape to hold the gears in their proper position during removal
and replacement.
1. Remove three screws and remove the Process Drive Motor and Gearbox.
2. Disconnect the wiring harness from the Process Drive Motor.
Replacement Notes:
Caution
If the Process Gearbox is not re-installed with the gears in the correctly
aligned and “pinned” positions, the printer will not function correctly and
could be damaged. Refer to the
"Homing the Process Gear Drive Train" on
page 6-8.
Caution
Be careful of the wiring harness to the Process Drive Motor and other nearby
wiring. If the wires are pinched during reinstallation damage to the
electronics module will occur. Ensure that the harness is routed via the
cutout in the gearbox frame (see figure on page 8-51).
Caution
Before installing the Process Gearbox, use a slotted screwdriver to rotate the
DM Camshaft 360º clockwise to ensure that the head tilt system is in the
home position.
Caution
Seat the Process Drive Motor and Gearbox and seat all three screws before
torquing the screws to final tightness. Torquing the screws individually
before seating all components, can put undue strain on the mounting bosses.
Caution
When reinstalling the gearbox, the hole in the bottom mating gear should be
aligned with the arrow embossed on the ground plane. The hole in the upper
mating gear should be aligned with the adjacent hole in the frame (see figure
on preceding page). Remove pins from the new gearbox after installation.
Note
Ensure that the drum heater harness, Y-Axis encoder harness, and the drum
fan harness are replaced in the cable restraint on the gearbox.

Xerox Phaser 8400 Specifications

General

Brand	Xerox
Model	Phaser 8400
Category	Printer
Language	English