Zte ZXR10 GER - Page 179

Chapter 11 Network Protocol Configuration
Confidential and Proprietary Information of ZTE CORPORATION 157
address. The address serves as default route in routing table.
 255.255.255.255 is a destination address used for broadcast
and cannot serve as a source address.
 127. X.X.X is called loopback address. Even if actual IP
address of host is unknown, address still can be used to
stand for the "local host".
 Only IP addresses with host bits being all “0” indicate
network itself. An IP address with host bits being all "1"
serves as broadcast address of the network.
 For a legal host IP address, the network part or the host part
must not be all "0" or all "1".
Refer to below procedure for IP address on ZTE ZXR10 GER
router.
Router Command Line Interface has been accessed.
1. Enter into configuration mode by writing config terminal
command in global configuration mode as shown in
Table
196.
TABLE 196 CONFIG TERMINAL COMMAND
Command
Format
Command
Mode
Command Function
config
terminal
Exec Enters into global configuration
mode
Result: This enables to enter into global configuration mode.
2. To enter into interface configuration mode, use interface
<interface-number> command in global configuration mode
as shown in
Table 197.
TABLE 197 INTERFACE CONFIG COMMAND
Command
Format
Command
Mode
Command Function
interface
<interface-
number>
Global config
This enters into interface
configuration mode
Result: This enables to enter into interface configuration
mode.
3. To configure an IP address of an interface, use ip address
<ip-address> <net-mask> [<broadcast-address>] in
interface config mode as shown in
Table 198.
Purpose
Prerequisite
Steps